Convertible roof mal functioning

asked on Fri 09/11/2026
2002 | 911 Carrera Cabriolet | Electronics | Brookings, SD | 117000 miles

have a 2002 Porsche 911 (996) Cabrioletwith a convertible top problem.

The roof operates, but during normal opening it stops before reaching the fully open position and PIWIS stores Fault Code 05 – Maximum time exceeded (timeout).

The important issue is the calibration procedure. When I start roof calibration with PIWIS, only the convertible-top compartment lid (clamshell) moves a few millimeters. As soon as it leaves the closed/locked end-position switch, the calibration immediately stops with “Function inactive – end position not reached.” The hydraulic roof itself does not even start moving during calibration.

During normal operation, however, the compartment lid opens normally.

I have checked the following:

• Potentiometer 1 and Potentiometer 2 signals change smoothly during operation.

• With the roof closed PIWIS shows approximately Pot.1 = 0.80 V, Pot.2 = 1.12 V.

• When the roof stops during opening: approximately Pot.1 = 2.16 V, Pot.2 = 2.45 V.

• The compartment-lid potentiometer (Pot.2) has been mechanically adjusted to approximately 6.2 kΩ in the fully open lid position, according to the adjustment procedure I have.

• The convertible-top control module has already been substituted/tested.

• Pump wiring and polarity switching have been checked. The pump receives approximately 10.7–11.2 V under load, while battery voltage is approximately 12.3–12.5 V.

The hydraulic pump/motor was previously repaired because it had suffered both a mechanical and electrical failure.

My main question is:

What exact condition does the Porsche control module expect immediately after the compartment lid leaves its CLOSED end-position switch during calibration?

Does it expect a specific Potentiometer 2 voltage/position, another microswitch transition, or a particular learned/calibration value before it continues to unlock the front roof latch and operate the hydraulic system?

I would specifically like to understand why normal compartment-lid operation works, but calibration stops immediately after leaving the first end-position switch.

If possible, please refer to the Porsche calibration sequence or specifications rather than recommending parts replacement, because I want to identify which input is preventing calibration from proceeding.


Expert Answer:

  1. Top

    submitted by Chris Amond [MAV] on

    Good afternoon, please send me an email to [email protected] and I will email the entire convertible top section of the shop manual.

    Chris