986 S Toe settings (how much is too much?) for Autox

asked on Wed 04/01/2026
2002 | Boxster S | Performance Modifications | Hilton, NY | 110000 miles

Recently got my Boxster to have more front -camber (-3.2) and looking for suggestions for max toe out settings.

Or, is that enough -camber to get it close to 0?

Current setup:

-tires: Falken 660+ (225/40/18, 275/35/18)

-H&R lowering springs, Koni's

-Tarett anti roll bar (front/rear)

Current settings:

-front anti bar (full soft)

-rear anti bar (full stiff)

-front: Caster 8.4, Camber -3.2, Toe 0.05 both sides total 0.10 toe out

-rear: Camber -2.4, Toe 0.04 both sides total 0.08 toe in

This is what I ran roughly last year with only -1.7 Camber in the front. Struggled with under steer.

Thoughts?


Expert Answer:

  1. submitted by Pedro Bonilla [SFL] on

    For an autocross-focused Porsche Boxster S with −3.2 front camber, your current front toe-out is already on the aggressive side, and I would start by reducing it slightly rather than adding more. A good next test would be about 0.5 to 1.0 mm toe-out per front wheel, then tune from there based on turn-in and mid-corner grip.

    Your current front setting of 0.05 toe-out per side, 0.10 total, is in the range commonly used for autocross, where moderate toe-out can improve initial response. Guidance for performance setups often lands around 1-2 mm toe-out per wheel, while excessive toe can make the car darty and reduce grip once the tires are loaded.


    Yes, −3.2 front camber is enough that you are likely very close to zero toe being a reasonable baseline, especially if the car already rotates well enough and you want to reduce scrub. Autocross guidance generally treats toe as a tuning tool to balance turn-in against tire loading, so with that much camber, you usually do not need much toe-out to “help” the tire reach its slip angle.


    Try front toe closer to zero first, or a very small toe-out amount.

    If the car still pushes on initial turn-in, add toe-out in small steps.

    If it becomes nervous or loses grip in the slalom and longer corners, back it off.

    Your rear toe-in looks sensible for stability, and with the rear bar full stiff plus significant rear camber, I would be careful about making the rear too lively while chasing more front rotation. For autocross, the best setting is usually the smallest amount of front toe-out that fixes the push without making the car nervous.

    Happy Porsche'ing,

    Pedro