-
Notifications
You must be signed in to change notification settings - Fork 44
Transverter #2342
Copy link
Copy link
Open
Labels
bugSomething isn't workingSomething isn't workingexternal devicesFlexControl, MIDI, serial port, USB peripheralsFlexControl, MIDI, serial port, USB peripheralsmaintainer-reviewRequires maintainer review before any action is takenRequires maintainer review before any action is takenprotocolSmartSDR protocolSmartSDR protocol
Description
Metadata
Metadata
Assignees
Labels
bugSomething isn't workingSomething isn't workingexternal devicesFlexControl, MIDI, serial port, USB peripheralsFlexControl, MIDI, serial port, USB peripheralsmaintainer-reviewRequires maintainer review before any action is takenRequires maintainer review before any action is takenprotocolSmartSDR protocolSmartSDR protocol
Hi I am using AetherSDR V0.9.6
I use three transverters 144 432 and 70Mhz
Transverter 1 which is normally known as Transverter0 is for 144Mhz
Transverter 2 which is normally known as Transverter1 is for 432Mhz
Transverter 3 which is normally known as Transverter 2 is for 70Mhz.
I AetherSDR it appears the transverter buttons int the band switching section have been named 1 2 and 3 etc. instead of 0 1 and 2
This means that when I press the button marked 144Mhz the software changes to 432Mhz and if I press the button marked for 432Mhz the radio turns to 70Mhz. I can't access 144Mhz by pressing a band button.
However I can access 144Mhz by using the direct frequency entry.
I hope the above makes sense.
Peter