@SoftFever this option can cause slight issues with multi colour models when printing inner outer inner wall ordering mode. It causes wall reordering to fail on occasion due to the sharp corners generated by segmentation from painting + the increased spacing in the outer wall causing it to encroach to neighbouring perimeters and fail reordering in the right way.

If we are to enable this option by default, we should create a rule to disable it when IOI is enabled - maybe a pop up in the UI?

IOI is not relevant to this option anyhow. Despite what I had done/said in the past :)

@SoftFever this option can cause slight issues with multi colour models when printing inner outer inner wall ordering mode. It causes wall reordering to fail on occasion due to the sharp corners generated by segmentation from painting + the increased spacing in the outer wall causing it to encroach to neighbouring perimeters and fail reordering in the right way.

If we are to enable this option by default, we should create a rule to disable it when IOI is enabled - maybe a pop up in the UI?

IOI is not relevant to this option anyhow. Despite what I had done/said in the past :)

Haha, I've been waiting to say this: "I told you" ;)
The option is only useful for inner-outer by design.
I will push another change to disable it when outer-inner or sandwich mode is used.

I know I know …. 😁😆edge case but why have it 😬😁

I know I know …. 😁😆edge case but why have it 😬😁

Changed #10687

Thank you :)